chopping up my 66 parts car
chopping up my 66 parts car
As my time allows I will be chopping up my parts car. It has the telescoping steering wheel with cornering lights, cruise, rear defrost, manual windows. The back glass was broken out when I got the car. Most of the rear end is toast. I will check back in as I can. Email works best for contacting. Thanks
- Doc Hubler
- Posts: 363
- Joined: Thu Sep 27, 2012 9:37 pm
- TOA Membership Number: 992
- Years Owned: 1967
Re: chopping up my 66 parts car
Don't know if there's any possibility. do you have the plastic corners on lower front end? They were black plastic splash panels on each front side. In the center was a rubber apron as well (also served as an air dam as well perhaps). I have one that is still intact, the other was broken. I will see if I can find a picture of one if that's helpful. Thanks!
- Trailrunner
- Posts: 22
- Joined: Sun Dec 23, 2012 9:27 am
- TOA Membership Number: 0
- Years Owned: !967 Toronado
- Location: Bend,Oregon
Re: chopping up my 66 parts car
I'm interested in dash parts. If you have pictures of the instrument
panel, ac on the dash , etc. and other assorted parts.
Also interested in anything comfortron.
Thanks
Ross
panel, ac on the dash , etc. and other assorted parts.
Also interested in anything comfortron.
Thanks
Ross
Re: chopping up my 66 parts car
I will be at the location where I store my parts car today or tomorrow and will get the requested photos. Sorry about the delay in response. My work has been crazy lately.
-
- Posts: 16
- Joined: Fri Apr 04, 2014 9:44 am
- TOA Membership Number: 0
- Years Owned: 1969 Oldsmobile Toronado
Re: chopping up my 66 parts car
You wouldn't happen to have the front metal skirt that goes under the front bumper.... Some idiot tryied to pulling mine with a chain
- Otto Skorzeny
- Posts: 1720
- Joined: Fri Feb 28, 2014 12:41 pm
- TOA Membership Number: 0
- Years Owned: 1966 Toronado
Re: chopping up my 66 parts car
Hi duwen,
I sent you a couple of requests via email but don't know if you got them.
Need:
Metal wiper blades
Umbrella shaped hood bumper
Z shaped metal trim for both arm rests
Lug wrench and jack hold down parts
Trans kickdown switch
What does the carburetor look like? Might be interested in a spare.
I sent you a couple of requests via email but don't know if you got them.
Need:
Metal wiper blades
Umbrella shaped hood bumper
Z shaped metal trim for both arm rests
Lug wrench and jack hold down parts
Trans kickdown switch
What does the carburetor look like? Might be interested in a spare.
Who is online
Users browsing this forum: No registered users and 3 guests