Page 1 of 1

chopping up my 66 parts car

Posted: Mon Apr 07, 2014 7:48 pm
by duwen10
As my time allows I will be chopping up my parts car. It has the telescoping steering wheel with cornering lights, cruise, rear defrost, manual windows. The back glass was broken out when I got the car. Most of the rear end is toast. I will check back in as I can. Email works best for contacting. Thanks

Re: chopping up my 66 parts car

Posted: Mon Apr 07, 2014 8:02 pm
by Doc Hubler
Don't know if there's any possibility. do you have the plastic corners on lower front end? They were black plastic splash panels on each front side. In the center was a rubber apron as well (also served as an air dam as well perhaps). I have one that is still intact, the other was broken. I will see if I can find a picture of one if that's helpful. Thanks!

Re: chopping up my 66 parts car

Posted: Wed Apr 09, 2014 7:05 am
by Trailrunner
I'm interested in dash parts. If you have pictures of the instrument
panel, ac on the dash , etc. and other assorted parts.
Also interested in anything comfortron.
Thanks
Ross

Re: chopping up my 66 parts car

Posted: Fri Apr 11, 2014 4:48 am
by duwen10
I will be at the location where I store my parts car today or tomorrow and will get the requested photos. Sorry about the delay in response. My work has been crazy lately.

Re: chopping up my 66 parts car

Posted: Fri Apr 11, 2014 12:04 pm
by Zeppelin
You wouldn't happen to have the front metal skirt that goes under the front bumper.... Some idiot tryied to pulling mine with a chain :shock:

Re: chopping up my 66 parts car

Posted: Sat Apr 12, 2014 1:02 pm
by Otto Skorzeny
Hi duwen,

I sent you a couple of requests via email but don't know if you got them.

Need:

Metal wiper blades
Umbrella shaped hood bumper
Z shaped metal trim for both arm rests
Lug wrench and jack hold down parts
Trans kickdown switch

What does the carburetor look like? Might be interested in a spare.