Page 1 of 1

Custom Lunati Roller cam

Posted: Mon Sep 09, 2013 3:51 pm
by bluecab
Used only for mock-up in my 425 hydraulic roller conversion.
Base circle was a bit too big.

221/221 @.050 on 110 LSA

.542/.544 lift

Would be good in a 455 and ?

$250 or BO ( cost $325.)

PM with questions,

David

Re: Custom Lunati Roller cam

Posted: Thu Sep 04, 2014 4:10 pm
by bluecab
Bump.

Still here. Still new.

All offers considered!

Re: Custom Lunati Roller cam

Posted: Tue Oct 14, 2014 3:31 pm
by andy96
what is the duration and overlap...that lift is a bit much. i have a 455 and wanted to take it to just above the w34 specs

Re: Custom Lunati Roller cam

Posted: Tue Dec 02, 2014 10:12 am
by bluecab
Sorry, I did not see your earlier post.

These are the specs from the cam card in the box.


Lunati P/N 20429909

Grind 18-R221G-R221C

Lift At Valve: .545 intake .542 exhaust

Advertised Duration: 285 intake 279 exhaust

Duration at .050 lift 221 intake 221 exhaust

Lobe Separation 108 degrees

Custom ground for my 425 application using hydraulic rollers, base circle was too big.

Make offer

Re: Custom Lunati Roller cam

Posted: Wed Jan 28, 2015 4:57 pm
by bluecab
TTT