Howdy Toroites,
Anybody know where one can track down the mounts used between the torsion bar support brace and the frame rails? Theay are two separate cushions, upper and lower, with the upper having a steel sleeve molded to it.
Any suggestions are appreciated.
Torsion Bar Support Mounts
- Chazzer
- Posts: 120
- Joined: Mon Jul 13, 2009 7:17 pm
- TOA Membership Number: 146
- Years Owned: 1968 Ocean Mist Metallic, purchased September 2005. Ripped into a kazillion pieces in 2010 for a full blown resto. A few more kinks to work out and she’s almost done.
- Location: Ontario, Canada
Torsion Bar Support Mounts
Cheers, Jim
TOA# 146
TOA# 146
-
- Posts: 208
- Joined: Sat May 21, 2011 5:51 pm
- TOA Membership Number: 38
- Years Owned: 1970 multiple
Re: Torsion Bar Support Mounts
Not ever seen them except as salvage from decent cars. You can take the rubber parts (decent and undeformed) and gently bead blast them and then soak them in silicone. They come out good enough for re-use. The steel parts are less likely to be found intact but can be obtained from decent desert cars. CB
Return to “Wanted: Parts and Misc”
Who is online
Users browsing this forum: No registered users and 59 guests