I need some professional advice, to be sure of something before I make an offer for a set of wheels from a '67Toronado I used to own.
I'm sure some of you remember the '67 Toronado that I could not afford to restore and had to let go. it had a set of Boyd Coddington wheels that I *believe* were "one-off-custom-made". I now have another vehicle that I *think* those wheels might fit properly, but I have to be sure of the SIZE of the bolt pattern.
Am I right in thinking the '67 Toronado uses a 5 x 5 inch or 5" x 127 mm bolt pattern?
This is the same bolt pattern as the '70s model 1/2 ton 2WD Chevy pickup trucks, right?
1967 Bolt pattern?
-
- Posts: 54
- Joined: Tue Dec 02, 2014 5:41 pm
- TOA Membership Number: 1138
- Years Owned: 1967
I have one, but it's needs exceed my abilities and I'm putting it up for sale on EBay.
1967 Bolt pattern?
--
Dennis D. Calhoun
AKA Grasshopper
Dennis D. Calhoun
AKA Grasshopper
- Otto Skorzeny
- Posts: 1721
- Joined: Fri Feb 28, 2014 12:41 pm
- TOA Membership Number: 0
- Years Owned: 1966 Toronado
Re: 1967 Bolt pattern?
Bolt Pattern 5 on 5"
Width 6 inches
Offset +3.25 inches
Backspacing 6.75 inches
Load Rating 1600 pounds
Width 6 inches
Offset +3.25 inches
Backspacing 6.75 inches
Load Rating 1600 pounds
-
- Posts: 54
- Joined: Tue Dec 02, 2014 5:41 pm
- TOA Membership Number: 1138
- Years Owned: 1967
I have one, but it's needs exceed my abilities and I'm putting it up for sale on EBay.
Who is online
Users browsing this forum: No registered users and 20 guests