Search found 136 matches

by Mikel
Sun May 20, 2018 4:49 am
Forum: General Talk
Topic: Hello from Germany!
Replies: 210
Views: 797993

Re: Hello from Germany!

Gorgeous!
by Mikel
Sun May 13, 2018 8:49 am
Forum: General Talk
Topic: Hello from Germany!
Replies: 210
Views: 797993

Re: Hello from Germany!

Jelonek wrote:hallo everybody :)
today a one question to transmission : which one do i have , is that TH 425 or th400 ?? Toronado ist from 1966... :shock:

thanks...


TH425 is the front wheel drive version of the TH400. So TH425.
by Mikel
Fri May 11, 2018 9:34 am
Forum: Technical Talk
Topic: Turn signals
Replies: 4
Views: 9852

Re: Turn signals

The turn signal switch in a '66 is external, driven by a cable. It's very likely that the switch has been knocked out of alignment.
by Mikel
Wed May 09, 2018 2:15 pm
Forum: General Talk
Topic: Hello from Germany!
Replies: 210
Views: 797993

Re: Hello from Germany!

Thank you Jelonek. I will post pictures of my misadventures :shock:
by Mikel
Mon May 07, 2018 5:59 pm
Forum: General Talk
Topic: Hello from Germany!
Replies: 210
Views: 797993

Re: Hello from Germany!

Fantastic photos! Were you able to remove the A/C / heater box with the fenders on?
by Mikel
Sun May 06, 2018 6:42 pm
Forum: Technical Talk
Topic: EFI - best system?
Replies: 9
Views: 19985

Re: EFI - best system?

Toronadotrofeo wrote:I just did fitech efi
I had to do lots of mods like everyone said
Intake linkage and blocked off crossover due the heat I’m very very happy with it


Any performance/mpg changes?
by Mikel
Fri Apr 06, 2018 10:49 am
Forum: Technical Talk
Topic: 1966 Parts List
Replies: 7
Views: 18977

Re: 1966 Parts List

Thank you for taking the time to do this. Perhaps it can be turned into a sticky.
by Mikel
Fri Mar 23, 2018 4:37 pm
Forum: Technical Talk
Topic: Transducer for Comfortron Part I
Replies: 7
Views: 16523

Re: Transducer for Comfortron Part I

Looks like these guys overhaul comfortron components. I'm going to send them my transducer.

https://originalair.com/restoration-gm-controls
by Mikel
Tue Feb 20, 2018 5:53 pm
Forum: Technical Talk
Topic: Front Hub Bearing Removal
Replies: 9
Views: 14758

Re: Front Hub Bearing Removal

I used two 5/16" steel plates to hold the bearing retainer in a press and I was able to press the inner hub out of the bearings.
by Mikel
Sat Feb 17, 2018 4:31 pm
Forum: Technical Talk
Topic: Final drive seals
Replies: 4
Views: 8932

Re: Final drive seals

Thank you. Another problem - After resealing my 75ish final drive, I noticed that the driver's side output flange has about 0.040" of side to side play, and about the same in in-out play. I can see the driver's side diff gear moving with it. I have a couple of '66 final drives and that flange i...

Go to advanced search