Toronado.org

My brother just brought me the original engine for my 69 W-34. See pic. It is covered in an inch of grease and grime but it still runs good. I will just clean it up, new seals and paint it. When the engine is out I will strip the engine bay and repaint it as well. Can anyone give me an idea on the w...

Here is a link to a 68 for sale if anyone is looking for one.
http://prescott.craigslist.org/cto/3887071346.html

I just found the numbers matching w-34 engine for my toro!! :D It is in the gmc truck that my dad swapped out a big block chevy for the 455. Luckily my brother now has the truck and he confirmed it is the right engine. Looks like I will be pulling some engines and driving to Montana. I can't believe...

I need a new three wire relay for my ac system. When I took it to the ac shop they said it was bad. You can't turn the ac off with the switch it will only turn off once you turn off the car. Where can I get one?

I just did mine and it was not easy. I bought a ball joint tool from harbor freight. I started to strip it because I had tightened it so much. Once I got it that tight I started hitting it as hard as I could with a hammer. It eventually came lose after a good hour or so. I don't know if that was the...

Does anyone know what the lowest ride height you can do without causing any problems? I want to lower my 69 toro as much as I can.

Here is a cute picture of my daughter wearing my new hat I got for Christmas.

I would love to be with you when your are driving it around. I am sure it will be getting a lot of looks. Luckily it is almost as much fun to work on them as it is to drive them.

In the 69 service manuel on page 5-35 it says to use a special tool to adjust the push rod length on the power brakes. Since I don't have the tool does anyone know what the measurement "A" should be for the single and the tandem diaphragm?

Kind of sounds like a warped rotor. They are generally worse at low speed.